For centuries, craftspeople who work with full glass have relied on a rare earth compound called Cerium Oxide to polish and remove light scratches from glass of all kinds. They still do. And you are able to, too. No material is more effective, easier or versatile to use for basic glass polishing, restoration and scuff, scratch and stain removal.
Cerium Oxide powder can also be a less expensive solution to most pre mixed polishing compounds already on the market. glass scratch repair with water right into a slurry along with a little goes a very long way. And if there’s some slurry left over as soon as the task is done, you do not throw it out. Just let it dry out so you can re-use it later on simply by adding water.
In case you are a do-it-yourselfer with even moderate skills, all you need to bring lightly scratched windows, tabletops, mirrors, automotive glass or even headlights like a pro is a bit of Cerium Oxide, a felt buffing controls and an electrical drill to attach it to.
If you’ve grime on your stains or glass on a shower door due to water that is hard and in addition they don’t come off with household products, Cerium Oxide is going to take proper care of the issue.
First of all, what is a “light” scratch? The rule of thumb (literally) would be that if you can distinctly feel a scratch in the glass of yours with a fingernail, it could be way too serious to polish out and the chance of aiming to do it yourself is most likely not worth it. Nonetheless, in case you have a hazy mass of superficial scratches caused by keys or coins, it’s Cerium Oxide on the rescue.
Cerium Oxide and a felt buffing wheel aproximatelly 3 inches in diameter are found online. Remember, you don’t require a lot. Here’s the way to do it:
• Clean the area you’re planning to work on, using a lint free paper or fabric cloth
• Get two small plastic tubs, a pint to a quart in size and fill a single halfway with water
• Place the buffing steering wheel into the water to let it get thoroughly damp, but not dripping wet
• Scoop a couple TBSP of Cerium Oxide into another tub and add a splash of water
• Use a plastic knife or perhaps spoon to stir the mixture and keep adding small quantities of h20 until the slurry grows to the consistency of quite heavy cream. (It’s entirely safe to check out with your bare finger. And don’t be concerned if there are small specks that don’t completely dissolve.)
• Attach the dampened polishing wheel to your electricity tool and dip it into the slurry
• Place the polishing wheel on the work area and rev up your drill
• Keep the pad moving continually side to side and in a circular motion
• Keep buffing until the slurry is practically dry (CAUTION: Be certain to never buff the glass when it is dry. This can result in the cup to overheat and crack.)
• When the slurry has dried, clean it off
• If the glass hasn’t been cleared up to the satisfaction of yours, you just need to replicate the buffing process with the slurry dampened pad
That is all there is to it. And don’t forget about, the slurry may be stored until it is dried out and then re activated by merely adding water. Happy polishing!